Drip edge installation
The metal at the roof edge
Decking is the structural sheet the roof covering is fixed to, and it is the thing a long-running leak destroys. Plywood or OSB that has been repeatedly wet delaminates and loses the ability to hold a nail, which means new shingles over it will not stay fixed. It is found during a repair rather than before — nobody sees it until the covering comes off — so it is usually a variation on the original scope rather than something quoted up front.
Colfax gets the full range — freeze-thaw cycling through winter, severe convective storms with hail and straight-line wind in spring and summer, and enough temperature swing between them to work every joint on the roof loose. Freeze-thaw is the quiet one: water finds a hairline gap in flashing, freezes overnight, expands, and opens it slightly wider, repeating through a McLean County winter until a joint that was watertight in October is leaking by March. Spring brings the loud damage, and derechos have put straight-line wind through this region at speeds that take ridge caps and whole shingle courses. Housing stock here is older than average, which means a lot of roofs where the flashing has already been through several decades of that cycle.
Colfax has a population of about 996, and the housing stock here sets the pattern for what fails first on a roof.
Because it cannot be seen until the covering is lifted. Any honest quote prices decking as a per-sheet rate that applies only if it is needed, rather than guessing at it — and tells you before replacing more than was discussed.
Sheets that got damp once and dried quickly are usually fine. Sheets that have been repeatedly wet delaminate — the plies separate — and that is permanent. The test is whether it still holds a fixing.
The metal at the roof edge
Concrete and clay tile
Rubber flat roofing
Crown, cap and masonry
Keeping debris out of the gutter
Lifting panels for roof work
You will get a straight answer on whether Colfax needs someone out today or whether it can wait — before anyone quotes you for anything.
Call (706) 696-1888